Vacumatic Pellet Remover (Tool HT-B)

A tiny curved spatula, slightly smaller in width but much thinner (flatter) than the spoon on HT-A.   This is a double sided tool with identical ends on each side. The tip of this tool measures 0.076 inches – good for aluminum pellet retainers.  Works great on Aluminum Vacumatic filling unit socket pellet removal, and  It’s also useable on Hard rubber sockets, but HT-BC has a similar shape and is better suited for the smaller hard rubber sockets and it's less likely to cause breakage in hard rubber. 

Again, don’t get the idea that you’re just going to reach in there and pluck that pellet out while it’s cold, dry, and tight.  You need to follow the pellet removing instructions under “REPAIRING A VACUMATIC FILLING UNIT”. That should help you ease the pellet out without damage to the pellet retainer.  Made from German Stainless steel.

**Note: you need to use our bud burr to put a tiny hole in the old pellet before using these tools if you're using them to remove a pellet.